Electrical Engineering Fundamentals By Vincent Del Toro Pdf May 2026

Prompt A — Innovation case: Propose a compact, low-cost power-supply module for a battery-powered sensor node requiring 3.3 V at 100 mA from a 3.7 V Li-ion cell. Include topology choice, efficiency considerations, thermal constraints, component selection rationale, and brief EMI mitigation strategies.

Problem 5 — Op-amp design (15 pts) Design an inverting amplifier with gain -10 using a real op-amp whose open-loop gain Aol(s) ≈ 10^5/(1 + s/2π·10 Hz). a) (6 pts) Choose Rf and Rin values (standard decade resistances) to realize the closed-loop midband gain -10 and justify choice. b) (5 pts) Compute the closed-loop bandwidth approximately using op-amp open-loop dominant pole. c) (4 pts) Discuss one stability concern with using very large feedback capacitances in the feedback network. electrical engineering fundamentals by vincent del toro pdf

Problem 4 — Resonant circuits & bandwidth (12 pts) A series RLC has R=20 Ω, L=100 μH, C chosen so resonant frequency fr = 1 MHz. a) (4 pts) Find C. b) (4 pts) Compute Q factor and bandwidth (BW). c) (4 pts) If R is halved, state qualitatively how fr, Q, and BW change. Prompt A — Innovation case: Propose a compact,

Part C — Design, analysis & applications (50 pts) Problem 7 — Filter synthesis & Bode (20 pts) Design a second-order Butterworth low-pass filter with cutoff fc = 1 kHz using an active Sallen–Key topology with unity gain buffer. Use standard component values within a factor of two. a) (6 pts) Provide component values (R1, R2, C1, C2) and show normalized component selection for Butterworth (Q=0.707). b) (6 pts) Derive the transfer function H(s) and show the -3 dB cutoff condition. c) (8 pts) Sketch (or describe numerically) magnitude Bode plot points at 10 Hz, 100 Hz, 1 kHz, 10 kHz, and 100 kHz (provide gains in dB). a) (6 pts) Choose Rf and Rin values

Problem 8 — Digital electronics & interfacing (15 pts) Given a microcontroller GPIO pin with output high 3.3 V (max source 20 mA) driving an LED requiring 10 mA at 2.0 V forward voltage. a) (5 pts) Calculate the resistor value and nearest standard 5% resistor to use. b) (5 pts) If the LED must be driven at 40 mA, propose a simple transistor driver (specify transistor type, resistor calculations, and protection). c) (5 pts) Explain briefly why direct MCU driving at 40 mA is discouraged.

Problem 9 — Practical measurement & instrumentation (15 pts) You must measure a small AC voltage (peak 20 mV) in presence of large common-mode interference (~10 V) using an instrumentation amplifier built from op-amps. a) (6 pts) Sketch the schematic conceptually (describe stages: input filtering, INA, gain, common-mode rejection). b) (5 pts) Choose an INA gain to get ~2 V full-scale output and compute resistor values or gain-setting component. c) (4 pts) List three practical techniques to maximize CMRR and reduce noise in this measurement.

Duration: 3 hours Total points: 200